twin raptors on ICH5R , what are your resaults?

red_alert753 · 01-31-2005, 03:48 PM

so i got 2 36gb raptors on the ich5r of the gig 8knxp and i get anywhere from 90 to 100 mb/s every time, anyone else running raid0?
thanks

alien resident · 01-31-2005, 03:50 PM

same set up here. never checked. what program are you using ?

Zulee · 01-31-2005, 04:07 PM

precast · 01-31-2005, 06:47 PM

I have dual 36GB raptors in Raid 0 on my P4C800E.

I get 71.5MB/s average using HD Tach, FWIW.

red_alert753 · 01-31-2005, 10:07 PM

i was using hd tach too...
you might want to check those raptors, i sent one of mine back cause it was stalling from time to time, as i recall my resaults were around the 60's at the time...
may be the controller of the mobo though...

bqtchef · 02-18-2005, 03:34 PM

I get 190mb burst speed with my raptors 36 gig on the ICH5R thru the IC7 MAX 3 abit mobo.

treyeod · 02-19-2005, 05:12 PM

P4C800E-Deluxe 36GB Raptors in RAID 0 getting average of 98MB/s, using 128kb stripe size,
BQTChef, what stripe size? that is smokin' fast!

patentman · 03-05-2005, 06:35 PM

Sandra2005 bench:
WD1600JD Raid0 on Promise ->75Mb/s
WD800JD Raid0 on ICH5R ->87Mb/s

Smurfer · 03-06-2005, 12:53 PM

First pic are the raptors raid 0, second is the ITE raid 0 2 WD JB 80's & third is the new Seagate 200GB ATA drive, fourth is the WD JB 80.
As you can see the Seagate ATA blows past both WD JB 80's no matter what configuration you put them in. But nothing compaes to the raptors that's for sure.

jbloggs · 03-14-2005, 06:53 PM

2 X 74GB Western Digital Raptors in RAID0 on ICH5R con, Asus P4P800 E Deluxe, 3.4GHz Northwood, 2x512MB OCZ PC3200 Platinum rev 2.

alien resident · 03-17-2005, 11:44 PM

I'm a little concerned . My results are in the pic.

My burst speeds seem to be close to you guys BUT the sequential read is no-where near you all.

epicbard · 03-17-2005, 11:47 PM

there were a lot of tests and stuff with the raptors and ich5r a while ago... might wana search

alien resident · 03-18-2005, 02:39 PM

hey guys can someone enlighten about something else. I just noticed that my sequential read line is all jagged and up and down. Most of yours start high and run in pretty much a straight line and taper off. What the heck is going on. ???

kswiss · 03-18-2005, 02:48 PM

I would also like to know the answer to this question, in addition what stripe size is everyone using on their raptors?

Quote:

Originally Posted by alien resident

hey guys can someone enlighten about something else. I just noticed that my sequential read line is all jagged and up and down. Most of yours start high and run in pretty much a straight line and taper off. What the heck is going on. ???

patentman · 03-20-2005, 11:26 AM

Quote:

Originally Posted by alien resident

hey guys can someone enlighten about something else. I just noticed that my sequential read line is all jagged and up and down. Most of yours start high and run in pretty much a straight line and taper off. What the heck is going on. ???

I think I have an answer on this but I sure would like a feedback.
When I benched the drives were empty and found it pretty jagged and up and down.Then when I had some files filling about 10% of one partition and re-benched I found the line in that storage point (point the specific filled somehow partition is/starts) to be straighten.
The more filled Hdd the more the straight line is.

Also found when setting PCI speed at 36Mhz the bench gets a little better in sequential read and a more better in burst speed but only for SATA RAID not for the ATA drive which remains the same.

01-31-2005, 03:48 PM	#1
red_alert753 Registered User Join Date: Oct 2003 Posts: 37	twin raptors on ICH5R , what are your resaults? so i got 2 36gb raptors on the ich5r of the gig 8knxp and i get anywhere from 90 to 100 mb/s every time, anyone else running raid0? thanks
(Offline)

01-31-2005, 03:50 PM	#2
alien resident a xeno..what ?? Join Date: Oct 2003 Location: Michigan Posts: 2,104	same set up here. never checked. what program are you using ? __________________ My Rig AMD FX-60 \| Asus A8N32-SLI Deluxe \| 2x1Gb Corsair XMS 3500LL Pro \| 2X Asus 7900 GTX in SLI \| OCZ 600W PSU \| Koolance EXOS-1 with CPU-305-V06 Block \| Razer Copperhead Chaos with eXactmat My Laptop USED Alienware Area-51 : Intel P4 1.8 Ghz \| Intel i845M mobo \| 2x512 Corsair \| ATI Mobile 7500 Radeon \| Samsung 100Gb HD \| Dual boot OS : XP Home & Ubuntu Linux \| Razer Diamondback Wife's Rig Intel P4 3.4c @ 3.6 Vcore 1.5625v \| Kingston HyperX 1 Gb (512x2) DDR434 2.5,3,3,7 Vdimm 2.8v \| Gigabyte GA-8KNXP Rev 2.0 FH BIOS \| WIN XP Pro Sp 2 \| Powercolor X800 XT PE \| SB Audigy 2 ZS \| 36Gb Raptors X 2 RAID O 128k Stripe \| Liteon 52X/16X CD/DVD ROM \| Antec True 550W PSU \| MSI Floppy \|
(Offline)

01-31-2005, 04:07 PM	#3
Zulee Join Date: Dec 1983 Join Date: Oct 2002 Posts: 455	__________________ < ThermalTake Tsunami >< HiperGroup Type R 480W >< P4P800 >< P4 Prescott 3.2@3.8GHz, Idle: 39C, Load 55C >< Zalman CNPS7700Cu >< 2xDiamondMax10 250GB 16MB RAID0 >< Selectra PC3200 2x1024MB 1:1 235MHz, 2.5,3,3,6 >< LeadTek 6800LE (12x1/6) @ 420/900 >< SB Audigy >< NEC-ND3500A >< MX1000 >< Hyundai L90D+ 19" 8ms > 3DMark03 3DMark05 Last edited by Zulee : 02-19-2005 at 05:15 PM.
(Offline)

01-31-2005, 06:47 PM	#4
precast Registered User Join Date: Aug 2003 Location: Southwestern PA Posts: 299	I have dual 36GB raptors in Raid 0 on my P4C800E. I get 71.5MB/s average using HD Tach, FWIW.
(Offline)

01-31-2005, 10:07 PM	#5
red_alert753 Registered User Join Date: Oct 2003 Posts: 37	i was using hd tach too... you might want to check those raptors, i sent one of mine back cause it was stalling from time to time, as i recall my resaults were around the 60's at the time... may be the controller of the mobo though...
(Offline)

02-18-2005, 03:34 PM	#6
bqtchef Registered User Join Date: Oct 2004 Posts: 1	I get 190mb burst speed with my raptors 36 gig on the ICH5R thru the IC7 MAX 3 abit mobo.
(Offline)

02-19-2005, 05:12 PM	#7
treyeod Registered User Join Date: Oct 2003 Location: Ft. Walton Beach, FL Posts: 208	P4C800E-Deluxe 36GB Raptors in RAID 0 getting average of 98MB/s, using 128kb stripe size, BQTChef, what stripe size? that is smokin' fast! __________________ 2.8C@3.219 on P4C800E-Deluxe 2X512 Mushkin LvlII PC3500 230FSB 1:1 23258T @2.85V Antec1080AMG Antec 430W,Zalman7000A-AlCu 2X36.7GB Raptor RAID0, 120GBWD 120GBMaxtor, Lite-On LDW811S, Lite-On48X24X48, Sapphire 9600XT, XP PRO SP1
(Offline)

03-05-2005, 06:35 PM	#8
patentman Modded Person Join Date: Feb 2001 Location: Athens,Greece Posts: 2,266	Sandra2005 bench: WD1600JD Raid0 on Promise ->75Mb/s WD800JD Raid0 on ICH5R ->87Mb/s __________________ P4C800-E DELUXE, 3.2E D0 218FSB 1:1 2.5 2368 (up to 240 stable 5:4), Zalman CNPS7000B Al-Cu, 2x512 TwinMos PC3200, Chieftec LBX-03, Chieftec HPC-420, 2x WD1600JD Raid 0, 2x WD800JD RAID 0, WD1200JB, WD800BB, NEC ND3500A, 6800LE, AverMedia TvStudio 303, Zoom 56K, USR9105, SB Live! and and old but too modded CUSL2 !!!
(Offline)

03-17-2005, 11:44 PM	#11
alien resident a xeno..what ?? Join Date: Oct 2003 Location: Michigan Posts: 2,104	I'm a little concerned . My results are in the pic. My burst speeds seem to be close to you guys BUT the sequential read is no-where near you all. __________________ My Rig AMD FX-60 \| Asus A8N32-SLI Deluxe \| 2x1Gb Corsair XMS 3500LL Pro \| 2X Asus 7900 GTX in SLI \| OCZ 600W PSU \| Koolance EXOS-1 with CPU-305-V06 Block \| Razer Copperhead Chaos with eXactmat My Laptop USED Alienware Area-51 : Intel P4 1.8 Ghz \| Intel i845M mobo \| 2x512 Corsair \| ATI Mobile 7500 Radeon \| Samsung 100Gb HD \| Dual boot OS : XP Home & Ubuntu Linux \| Razer Diamondback Wife's Rig Intel P4 3.4c @ 3.6 Vcore 1.5625v \| Kingston HyperX 1 Gb (512x2) DDR434 2.5,3,3,7 Vdimm 2.8v \| Gigabyte GA-8KNXP Rev 2.0 FH BIOS \| WIN XP Pro Sp 2 \| Powercolor X800 XT PE \| SB Audigy 2 ZS \| 36Gb Raptors X 2 RAID O 128k Stripe \| Liteon 52X/16X CD/DVD ROM \| Antec True 550W PSU \| MSI Floppy \| Last edited by alien resident : 04-17-2007 at 06:45 AM.
(Offline)

03-17-2005, 11:47 PM	#12
epicbard mmm... bacon bits Join Date: Dec 2002 Location: Treehouse Posts: 4,266	there were a lot of tests and stuff with the raptors and ich5r a while ago... might wana search __________________
(Offline)

03-18-2005, 02:39 PM	#13
alien resident a xeno..what ?? Join Date: Oct 2003 Location: Michigan Posts: 2,104	hey guys can someone enlighten about something else. I just noticed that my sequential read line is all jagged and up and down. Most of yours start high and run in pretty much a straight line and taper off. What the heck is going on. ??? __________________ My Rig AMD FX-60 \| Asus A8N32-SLI Deluxe \| 2x1Gb Corsair XMS 3500LL Pro \| 2X Asus 7900 GTX in SLI \| OCZ 600W PSU \| Koolance EXOS-1 with CPU-305-V06 Block \| Razer Copperhead Chaos with eXactmat My Laptop USED Alienware Area-51 : Intel P4 1.8 Ghz \| Intel i845M mobo \| 2x512 Corsair \| ATI Mobile 7500 Radeon \| Samsung 100Gb HD \| Dual boot OS : XP Home & Ubuntu Linux \| Razer Diamondback Wife's Rig Intel P4 3.4c @ 3.6 Vcore 1.5625v \| Kingston HyperX 1 Gb (512x2) DDR434 2.5,3,3,7 Vdimm 2.8v \| Gigabyte GA-8KNXP Rev 2.0 FH BIOS \| WIN XP Pro Sp 2 \| Powercolor X800 XT PE \| SB Audigy 2 ZS \| 36Gb Raptors X 2 RAID O 128k Stripe \| Liteon 52X/16X CD/DVD ROM \| Antec True 550W PSU \| MSI Floppy \|
(Offline)

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode